DLM Dekstrip Flashing 235mm x3.1M - DS3-235

Model: DS3-235

DLM Dekstrip Flashing 235mm x3.1M - DS3-235

  • Length: 3.1meters
  • Width: 235mm
  • Material: EPDM based grey Thermoplastic Electomer (TPE) 
✔ The Dekstrip edges contain an expanding aluminium strip (in concertina form) totally encased by the EPDM flashing.
✔ Dekstrip can be stretched and formed around most roof profiles and maintain that shape.
✔ Typical applications include bullnosing, where two different profiles intersect, curved parapet flashing, expansion joints in gutters, change of pitch and large round pipe penetrations.
✔ Fastening is done through the aluminium strip using suitable fasteners with a minimum 10mm head. In case of rivets use a 10mm washer under head. 
✔ EPDM based thermoplastic elastomer (TPE) will withstand temperatures from -50°C - 115°C and up to 150°C intermittently.
✔ Dekstrip can be painted (contact DLM for technical advise).

 



Flexible Cone Sleeve
Dektite cone shape eliminates seal breakdown due to vibration or expansion and contraction, while isolation of pipe from sheeting dampens noise levels.

Stress Isolation Points
Unique to Dektite, two flexible shoulders absorb distortion and stop transfer of stresses from base to cone, as unit is formed over roofing profile.

Bonded Aluminium Flange
Corrosion-resistant, malleable flange, evenly distributes fastening pressure and allows ease of hand-shaping on most sheet profiles.

Integrity of Flashing Shape
Minimal distortion after installation, maintains natural flashing shape and seal around pipe, while water run-off is improved.

UV Protection
Dektite products are resistant to ultraviolet light damage and will remain fully flexible under all conditions.

Easily Identified Sizing
Pipe diameter rings are clearly marked on the cone sleeve (metric and imperial) for cutting to match the appropriate pipe diameter.

Low Profile Design
Sleek, unobtrusive shape is designed to minimise silhouette on roofline, while managing to provide generous internal clearance for steep, angular installations.

Improved Waterproofing
Designed to strengthen sealant bond and improve waterproofing, the ribbed base also has a tapered edge to improve runoff and contribute to a superior waterproof seal.

Perfect for approved flues!
Dektite EPDM polymer flashings have been officially tested and conform to all Australian and New Zealand Standards on approved flue systems. EPDM withstands temperatures from -50°C - 115°C and up to 150°C intermittently. withstands temperatures from -60°C - 200°C and up to 250°C intermittently






Plumbing Plus © 2024