DLM Dektite Premium Black EPDM 150-300mm Pipe Size - DFE107B

Model: DFE107B

DLM Dektite Premium Black EPDM 150-300mm Pipe Size - DFE107B

  • Base: 456mm x 456mm
  • Pipe: 150-300mm
  • Pitch: 0-45

✔Most extensive range of Dektites 0 - 510mm penetrations, available in black and grey EPDM and silicone red for high temperatures.

✔Designed to enable practically any pipe flashing operation to be carried out within minutes, simple to install and very effective.

✔ The low profile cone not only looks good but provides a generous internal clearance, so even the steepest roofs are handled with ease.

✔ Around the base of the cone a flexible bead reduces stress on the flashing membrane.

✔ Suitable for flashing pipes that penetrate wall claddings.

✔ For a maintenance free seal on pipes from 0 – 510mm diameter, it’s much more than a flexible solution to pipe flashing, it’s a means of saving time and money. Dektite Premium The versatile solution

✔ Can also be used to flash square penetrations. Just add 30% to the pipe diameter and trim the cone to suit.

✔ EPDM withstands temperatures from -50°C - 115°C and up to 150°C intermittently.

✔ Silicone withstands temperatures from -60°C - 200°C and up to 250°C intermittently

✔ 20 Year Warranty

Flexible Cone Sleeve
Dektite cone shape eliminates seal breakdown due to vibration or expansion and contraction, while isolation of pipe from sheeting dampens noise levels.

Stress Isolation Points
Unique to Dektite, two flexible shoulders absorb distortion and stop transfer of stresses from base to cone, as unit is formed over roofing profile.

Bonded Aluminium Flange
Corrosion-resistant, malleable flange, evenly distributes fastening pressure and allows ease of hand-shaping on most sheet profiles.

Integrity of Flashing Shape
Minimal distortion after installation, maintains natural flashing shape and seal around pipe, while water run-off is improved.

UV Protection
Dektite products are resistant to ultraviolet light damage and will remain fully flexible under all conditions.

Easily Identified Sizing
Pipe diameter rings are clearly marked on the cone sleeve (metric and imperial) for cutting to match the appropriate pipe diameter.

Low Profile Design
Sleek, unobtrusive shape is designed to minimise silhouette on roofline, while managing to provide generous internal clearance for steep, angular installations.

Improved Waterproofing
Designed to strengthen sealant bond and improve waterproofing, the ribbed base also has a tapered edge to improve runoff and contribute to a superior waterproof seal.

Perfect for approved flues!
Dektite EPDM polymer flashings have been officially tested and conform to all Australian and New Zealand Standards on approved flue systems. EPDM withstands temperatures from -50°C - 115°C and up to 150°C intermittently. withstands temperatures from -60°C - 200°C and up to 250°C intermittently


Plumbing Plus © 2024