Kembla Trap Inlet 65mm - DIT065

Model: DIT065

Kembla Trap Inlet 65mm - DIT065

• All Kembla copper fittings distributed by Kembla are manufactured to the highest quality.
• All Kembla copper fittings are permanently marked to provide product tracing information for the life of the installation.
• Kembla copper fittings have unrestricted internal bores, and are designed with transitions and direction changes that provide maximum flow rates.
• Kembla copper fitting's mechanical and thermal strength protects the system from damage, both during installation and while in service.
• Kembla copper fittings are 100% UV stabilised
• Kembla copper fittings have a melting temperature of 1083°C
• Kembla copper fittings have a high mechanical strength and high impact resistance.
• Kembla copper fittings are fully approved for gas applications.
• Kembla has achieved AS 4041 'Material in Contact with Drinking Water' standard approval - the tightest international specification for systems used for drinking water.

INSTALLATION:

• Kembla copper fittings are designed to fit the end diameter of the tube closely for maximum joint strength. Any damage to the tube end should be repaired or cut off before making a joint.
• The ends of copper tube should be cut square to maintain the required overlap between the tube and fitting.
• Silver brazing is recommended for joints. Excess flux should be removed from around the joint after completion.
• Care should be taken not to overheat the tube or fitting in the brazing process.